skip to Main Content
(+1) 8665393032 info@netgearsupports.com
Netgear WiFi Range Extender
Netgear Wi-Fi Range Extender Setup

Your home’s or office Wi-Fi depends on every router, which spreads a signal to enable you to connect via the internet.
All routers possess a limited range, which can cause things complex if the range from one end of your house to the other is tangible. A Wi-Fi extender can expand a particular router’s signal to relinquish the remote zones of your home. Establishing this is surprisingly straightforward.

Why use Wi-Fi Range Extender Setup

The Wi-Fi range extender is one of the easiest, safest and fastest ways to extend the signal range of an existing Wi-Fi.

In most cases when we have a very weak network signal, we tend to find it very frustrating as we will encounter very slow network speed while surfing the internet and it’ll even take a lot of time to load just a page itself. Therefore, the Wi-Fi range extender has come to relief us all of all the stresses as well as the pressure which we always experience whenever we find ourselves in an area where there is less network coverage.

Netgear WiFi Range Extender Setup
Steps on how to set up the Netgear Wi-Fi Range Extender

The below-listed guides are necessary to be observed in other to set up the Netgear Wi-Fi Range Extender with ease. However, if you find it difficult to set up after following the below procedures; just give us a call via our customer care representative toll-free number 1-866-0533-032.

  • First and foremost, un-box the extender from its pack if you purchased it new.
  • Now the next step is to plug the Wi-Fi extender into the power source. There’ll be different LED lights that identify good and bad connections.
  • For a successful connection, the LED light turns green or amber color.
  • For an unsuccessful setup connection, the LED light turns red.
  • To ensure successful connection, endeavor to place the extender in the same room where the main Wi-Fi network router is and place it in between the router and the PC which is been connected with the Wi-Fi network to ensure a very strong connection.
  • On the router, search for the WPS button
  • To start up with, first, click on the WPS on the extender and then
  • Press the WPS button on the Wi-Fi router. By pressing this, the WPS led will appear in solid green when there’s the establishment of good connectivity between your Wi-Fi router and your extender.
  • If your Wi-Fi supports around 5GHz or above and you feel like you have to extend it, then all you have to do is to repeat the WPS process.
  • Unplug the extender and move it to a new location in between the router as well as whichever device that you may be used with your network.
  • Plug back the extender in the power source and then wait for the power LED light to turn on.
Back To Top